Configuring entries for NTP for authenticating to Active Directory (AD)
| Article:HOWTO40110 | | | Created: 2011-01-07 | | | Updated: 2011-01-07 | | | Article URL http://www.symantec.com/docs/HOWTO40110 |
FileStore will not join the AD domain if its clock is excessively out-of-sync with the clock on the AD domain controller. Ensure that Network Time Protocol (NTP) is configured on FileStore, preferably on the same NTP server as the AD domain controller.
To configure NTP on FileStore for authenticating to Active Directory
To set the NTP server on all of the nodes in the cluster, enter the following command:
System> ntp servername server-name
where server-name specifies the server name or the IP address you want to set.
Ensure that the NTP service is enabled with the correct IP address of the NTP server.
System> ntp servername 10.182.128.180
To enable the NTP server on all of the nodes in the cluster, enter the following command:
System> ntp enable
To display the NTP server on all of the nodes in the cluster, enter the following command:
System> ntp show
To check the FileStore clock, enter the following command:
System> clock show
|
|
Legacy ID
v45275969_v52225253
Article URL http://www.symantec.com/docs/HOWTO40110
Terms of use for this information are found in Legal Notices
Thank you.