Upgrading NetBackup Access Control (NBAC)

Article:HOWTO46894  |  Created: 2011-03-24  |  Updated: 2014-11-19  |  Article URL http://www.symantec.com/docs/HOWTO46894
Article Type
How To


Environment

Subject


Upgrading NetBackup Access Control (NBAC)

Note:

If NBAC is enabled, it is upgraded as part of the NetBackup upgrade. Refer to the NetBackup Install and Upgrade Guide for instructions about how to upgrade NetBackup. Make sure that current AT and AZ services are running when the upgrade is performed. If NetBackup is running in a cluster server, make sure that both services are running in the active node where NetBackup is running and the upgrade is performed.

The following procedure describes how to upgrade NetBackup Access Control (NBAC).

Upgrading NetBackup Access Control (NBAC)

  1. On the master server, stop NetBackup.

  2. Upgrade NetBackup.

    On the media servers and client computers, first stop NetBackup and then upgrade NetBackup. Note that the shared authentication and authorization packages are no longer used on media servers and client computers. These products can be removed if no other Symantec product is using them.

See About using NetBackup Access Control (NBAC)



Legacy ID



v32155824_v54411808


Article URL http://www.symantec.com/docs/HOWTO46894


Terms of use for this information are found in Legal Notices