Disabling the DMP paths on an initiator using Veritas Operations Manager 4.1
|Article:HOWTO65028|||||Created: 2012-01-04|||||Updated: 2012-01-04|||||Article URL http://www.symantec.com/docs/HOWTO65028|
In certain circumstances, you may want to perform maintenance operations on the initiators in your datacenter. For example, you may want to upgrade the firmware that has been installed on one or more initiators. In such situations, you may want to temporarily disable the Dynamic Multipathing (DMP) paths that connect these initiators to the storage, and re-enable these paths after the maintenance operations are completed. When you temporarily disable the DMP paths on an initiator, the communication to the storage is maintained through an alternative path.
To disable the DMP paths on an initiator
In the Veritas Operations Manager console, do one of the following:
In the Path Disable Confirmation panel, review the details of the DMP paths. To view the information on the relationship of the DMP paths with other storage resources in your datacenter, click View Associations Report.
In the Paths Disabled panel, review the details of the disabled paths and the commands that were run to complete the operation. Do one of the following:
To save and close the configuration and re-enable the DMP paths later, click Save&Close. If you choose this option, you can re-enable the DMP paths later using the options available on the Solutions page, or using the Unfinished Cases drop-down in the Start wizard panel.
Article URL http://www.symantec.com/docs/HOWTO65028