The dynamic disk group version is not upgraded after you upgrade SFW or SFW HA. If a service group in the previous configuration contains a dynamic disk group, you must upgrade its version after you complete the SFW or SFW HA upgrade.

You can upgrade the dynamic disk group, using the Veritas Enterprise Administrator (VEA) console or the CLI.

To upgrade the disk group, using CLI, run the following command. You must run this command for each dynamic disk group separately.

vxdg -gDynamicDiskGroupName [-T version] upgrade

Where,

DynamicDiskGroupName= Name of the dynamic disk group

version= Target version of the dynamic disk group

After the disk group version is upgraded, run the following command to verify the upgraded version.

vxdg -gDynamicDiskGroupName dginfo

Perform the following steps to upgrade the dynamic disk group version, using VEA. You must perform these steps for each dynamic disk group separately.