Backup Exec System Recovery One Time Virtual Conversion Step by Step - V2I to VHD for use in a virtual environment

Article:TECH136367  |  Created: 2010-01-09  |  Updated: 2014-05-20  |  Article URL http://www.symantec.com/docs/TECH136367
Article Type
Technical Solution


Issue



Backup Exec System Recovery / Symantec System Recovery One Time Virtual Conversion Step by Step - V2I to VHD for use in a virtual environment


Solution



 
1. Make a working copy of a full backup (V2I file) that will be converted to a VHD file for use in Microsoft's Hyper-V virtual environment.
 
2. Put this copy on a local disk on the Hyper-V server.

3. Install and run Backup Exec System Recovery / Symantec System Recovery.

Figure 1
 
 
4. Select the Tasks tab. Under Conversion, select One Time Virtual Conversion.

Figure 2
 

5. Choose Microsoft Virtual Disk (.vhd) and then Next.
 
6. Under View By, select Filename. Browse to the .V2I file. Apply credentials if necessary and then Next.

Figure 3
 
 
7. Choose a location for Temporary Files used during the conversion process.

Figure 4
 

8. Select Run windows mini set up except for Domain Controller images .
 
 
NOTE: In some troubleshooting scenarios, where a previous conversion did not permit the virtual system to boot appropriately, disable this option
 
Figure 5
 

9. Review the selections made during this process. When ready, press Next to proceed with the restore. (Warning: This may take a long time depending upon the size of the image.)

Figure 6
 

When it is done, a green check mark and the word Succeeded should appear.

Figure 7
 


 


Legacy ID



355405


Article URL http://www.symantec.com/docs/TECH136367


Terms of use for this information are found in Legal Notices