Correcting the pd.conf file after factory reset on an appliance.

Article:TECH177085  |  Created: 2011-12-15  |  Updated: 2012-01-03  |  Article URL http://www.symantec.com/docs/TECH177085
NOTE: If you are experiencing this particular known issue, we recommend that you Subscribe to receive email notification each time this article is updated. Subscribers will be the first to learn about any releases, status changes, workarounds or decisions made.
Article Type
Technical Solution

Product(s)

Issue



 After a factory reset operation is run on a NetBackup Appliance versions 2.0 and 2.0.1, the value of the OPTDUP_TIMEOUT attribute may get set to an empty string in the pd.conf file. The result is a parse error and the inability to read any additional attributes in the file. In addition, if the Fibre Channel is enabled, it is not honored.


Solution



 

 To correct this issue, you must edit the OPTDUP_TIMEOUT attribute in the pd.conf file. The attached file describes the process of making this change.


Attachments

Correcting the pd.conf file after factory reset on an appliance.
Correcting the pd.conf file after factory reset.pdf (86 kBytes)


Article URL http://www.symantec.com/docs/TECH177085


Terms of use for this information are found in Legal Notices