Screencasts - Hilfsvideos

Catalog job won't run

Created: 30 Apr. 2013 • Aktualisiert: 07 Mai 2013 | 3 Kommentare
Dieses Problem wurde gelöst. Siehe Lösung.

I am using Backup Exec 2010. I have pulled a tape off my shelf for a restore job. I have inventoried the job. But when I do the Catalog job, it begins with "Loading media"...but then after 10 minutes or so, the job status goes to "?Queued".

I saw a TechNote that said to go to Tools, Options, Catalog and 'Deselect" Use storage media-based catalogs. This change appeared to 'do something' in that the catalog job took a lil while longer to go to the "?Queued" state.

Any ideas as to how to catalog this tape?

Operating Systems:

Kommentare KommentareZum neuesten Kommentar

das Bild der CraigVs


try the following:

1. Stop the BE services and rename the Catalogs folder to Catalogs.old. Do NOT delete it.

2. Restart the BE services which should recreate the folder Catalogs.

3. Try running the Catalog job. If it succeeds, and you restore your data, then stop the BE services again, and rename Catalogs.old to Catalogs after deleting the temporary Catalogs folder.


Alternative ways to access Backup Exec Technical Support:

das Bild der pkhs

Check whether there is any outstanding alerts.

Also, disable the catalog in sequence option because your tape might not be the first one in the backup set.

das Bild der JustTryinToGetItToWorks

Craig...very good. This enabled me to run a catalog job. The job does take several hours to run. But it does run.

Thank you again.