Deployment Solution

We recently got some new 790 and 990 Dell computers and PXE didn't work with them. I went through the usual steps to install NIC drivers, etc. but they still wouldn't work. We were on sp4, so I upgraded our server to sp5 and have reinstalled PXE. PXE is working, but all of my client computers now get the 0xc000000f error when doing any imaging job - create or deploy. I have also installed the storage drivers from the Dell WinPE driver pack.

I'm not sure what to look at next...any ideas?

Thanks -Mike

There should be a log file in the DS server for rdeploy \\expressname\express\rdeploy check in the folders where rdeploy was executed x86 or x64. it might tell u more about the issue.

I had a similar, but not the same issue with our most recent batch of 990's.

It was resolved by pulling half the memory out of the 990. it would then pxe boot

When exactly do you get this error message? You say that PXE does the job, does rdeploy/ghost launch at all or it errors out before?