Endpoint Encryption

 View Only

  • 1.  Command Line Options for installing SEE Management Server on different partition?

    Posted Jan 04, 2016 08:51 AM

    Hi

     

    Our server has 2 partitions.  One is pretty much full.  The other one (D:) has tons of space.  I've been searching for a command line reference guide for installing the SEE Management Server utilizing MSIEXEC.

     

    Any help?  Thanks!



  • 2.  RE: Command Line Options for installing SEE Management Server on different partition?

    Broadcom Employee
    Posted Jan 07, 2016 08:47 AM

    hi,

    you can run the installation and at some point you will have to choose the destination of Symantec Endpoint Encryption Management Server (step 13 from below procedure):

    https://www-secure.symantec.com/connect/articles/symantec-endpoint-encryption-1101-management-server-installation

     

    please let me know if this is what you were looking for



  • 3.  RE: Command Line Options for installing SEE Management Server on different partition?

    Posted Jan 07, 2016 12:04 PM

    I get as far as "Please provide minimum of 5 Gigabytes free disk space to setup the Management Server."  C: does not have 5 GB.  D: has tons.  I only get as far as double-clickint the .msi file and clicking "Run" before I'm blocked.



  • 4.  RE: Command Line Options for installing SEE Management Server on different partition?

    Posted Jan 07, 2016 01:30 PM

    Also....let's say I have a program that can edit attributes within the installer file (like Orca).  Is there any particular attribute that I can change that will help get this installed on a different partition?  

     

    Thanks!



  • 5.  RE: Command Line Options for installing SEE Management Server on different partition?

    Posted Jan 11, 2016 09:05 AM

    OK, so, using Orca, I edited the table "LaunchCondition" and just removed the condition "(MINDISKSPACE=1)"...which allowed me to proceed and tell the installation to install to D: instead.


    So...fixed?  Guess I'll discover sooner or later if anything squirrelly happened, but the program seems to run fine....

     

    Thanks!