Configure LLT And GAB In A Veritas Cluster
Im about to add a new node to a cluster (Solaris OS and version 5.0 for the cluster) and I have set all the cabling to have the HB network working. The heartbeat links are connected correctly using a switch over the same VLAN.
I was checking if the HB links are up but not plumed, but they are in this state unknown.
root# dladm show-dev
igb0 link: up speed: 1000 Mbps duplex: full
igb1 link: unknown speed: 0 Mbps duplex: unknown
igb2 link: unknown speed: 0 Mbps duplex: unknown
igb3 link: unknown speed: 0 Mbps duplex: unknown
usbecm0 link: up speed: 10 Mbps duplex: full
Its the interfaces igb1 and igb2.
Im new at this and comparing to the other nodes and internet examples, their HB interfaces are up but NOT plumbed...
So, these interfaces - igb1 and igb2.- should be up just by plugging the cable or should I issue a command to do so?
Is there any checnking I can do to see where the problem is, if there is any?
Tks in advance,