creating a boot disk in ghost
Created: 21 Nov 2012 | Updated: 23 Nov 2012 | 2 comments
I have crated a a boot disk using winpe this works fine using a USB 3.0. I then created a boot disk using a USB 2.0 device on a HP elitebook 2570p. The bios can detect the drive but when it trys to boot it says drive read error. I am using ghost 2.5
nigel stout
Discussion Filed Under:
Comments 2 Comments • Jump to latest comment
...moved to the correct forum!
Thanks!
If you find this is a solution, please mark it as such.
Did you add and select the appropriate Vista 32 bit drivers for the SATA chipset on your HP Elitebook, as WinPE in Ghost is based on the Vista 32 bit kernel and therefore has only limited SATA support built in.
If your issue has been solved, please use the "Mark as Solution" link on the most relevant thread.
Would you like to reply?
Login or Register to post your comment.