Endpoint Protection

 View Only

  • 1.  Deployment freezes

    Posted Sep 13, 2011 02:54 PM

    I have SEP 12.1 installed on a 2008 R2 Standrad server and from there I am trying to push a new client package to a handfull of Win 7 clients.
    The Deployment wizard starts and then freezes at 0%.

    If I install locally I am able to do so. How should I proceed?



  • 2.  RE: Deployment freezes

    Posted Sep 13, 2011 03:17 PM

    check if uac is enabled on win7 clients

    try this document too , incase

    https://www-secure.symantec.com/connect/forums/client-deployment-failed#comment-5283271



  • 3.  RE: Deployment freezes
    Best Answer

    Posted Sep 13, 2011 03:17 PM

    Re-Run Management server configuration wizard from start all programs SEPM Management server configuration wizard

    & then try deploying the package

    Rather adding the package and then deploying it

    https://www-secure.symantec.com/connect/forums/sep-121-client-deployment-wizard-hangs



  • 4.  RE: Deployment freezes

    Posted Sep 13, 2011 07:43 PM

    Hello _Swami_,

    Try giving the following document a read and ensuring that you meet the recommended requirements mentioned in it.

    • You are having difficulty deploying the Symantec Endpoint Protection client through the network to a Windows Vista, 7, or Server 2008 system
    • http://www.symantec.com/docs/TECH165133
    Regards,
     
    James


  • 5.  RE: Deployment freezes

    Trusted Advisor
    Posted Sep 14, 2011 09:33 AM

    Hello,

    Here is an Article for you to follow on:

     

    Steps to prepare computers to install Symantec Endpoint Protection 12.1 client
     
     
    The Article states,
     
    Prepare Windows Vista, Windows Server 2008, or Windows 7 computers:
     
    Windows User Access Control blocks local administrative accounts from remotely accessing remote administrative shares such as C$ and Admin$. Perform the following tasks:

    ■ Disable the File Sharing Wizard.
    ■ Enable network discovery by using the Network and Sharing Center.
    ■ Enable the built-in administrator account and assign a password to the account.
    ■ Verify that the account has administrator privileges.

     

    Hope that helps you!!