Enable label type on tape label
Updated: 23 Sep 2010 | 3 comments
we have two versions of LTO tapes, L3 and L4. The barcodes have the L3 and L4 designators and the designators show when looking at the tape library but do not show when viewing from Backup Exec. Does anyone know how to make the L3 and L4 show in Backup Exec. We are running BE 12.5.
tks
ed
discussion Filed Under:
Comments
How long are your barcodes as
How long are your barcodes as libraries have to have a special mode enabled if they are longer than a certain length (off the top of my head I think this is something like 8 characters) Also Backup Exec cannot handle longer than 15 even after you enable the mode on the library. NOTE: this mode I refer to is NOT a Backup Exec setting it is a libary setting and for some reason with at least one manufacturers library model, the display panel on the library itself always shows the full barcode even when the mode has not been changed.
More
More Info
http://entsupport.symantec.com/docs/306559
If you are using a HP
If you are using a HP autoloader, then access the library using the Web interface and set the parameter Barcode Label Length Reported To Host to the appropriate length, i.e. 8. This parameter is located under the tabs Configuration --> System.
Would you like to reply?
Login or Register to post your comment.