IT Management Suite

I have created an image with -id switch (image all), but I am not able to return the image to same disk. 

The error that I receive is "abort: 40011, Destination driver too small" 

I am using Altiris 7.5 SP1 HF2 

Hello Emir,

Do try to have a look at the following article which may help you to resolve the issue :

http://www.symantec.com/docs/TECH106958

This message is most likely caused by a problem with the BIOS setup or Ghost's drive geometry detection. Do the following to resolve the issue:
 

• Use the -FIS switch.
  See the document Ghost Will Not Use All Space On a Drive.
• Use the drive-detection switches in Ghost.
  For instance, the following Ghost command fixed the problem when using an Adaptec 2940au hard drive controller card and doing a disk-to-disk clone from one 9.2-GB SCSI hard disk to another:
  
  ghost -clone,mode=copy,src=1,dst=2 -IR -OR -FFS -FNI -FIS -VDW
  
  
  The drive detection switches are listed in each Ghost user's manual and in the document Switches: Drive Geometry.
• Check the BIOS to ensure that the drive is set up correctly.
• Run Ghost with the Himem.sys file and the DOS16M switch.
  For instructions, see the document Error: "Unable to control A20 line" when starting Ghost.exe.
• For information about troubleshooting drive geometry detection in Ghost, see the document Interpreting and Using the GHSTSTAT.DMP Diagnostic File

Hi, 

I tryied that but it is not working with the flags. I have support case on this and I hope that they will solve it soon. 

Br

/Emir