I typically image devices from a CLI in a bat file from a winPE bootable flash drive. I can't seem to get the Slate to properly take an image using this. Using Ghost32 v11.5.1
I have tried using "ghost32.exe -noide -clone,mode=load,src=[source.gho file],dst=1 -sure" and "ghost32.exe -clone,mode=load,src=[source.gho file],dst=1 -sure". This is how I typically run on PC Hardware (i.e. HP dc7900-8200 and Lenovo M57-M91 boxes).
I can manually image from the GUI to the Slate but can't seem to properly ghost from the Command Line.
Any thoughts or suggestions would be greatly appreciated