Job Recurring changed to No and Job selection list cleared
I currently have several jobs running/created by one policy.
I have a disk to disk job running M-Th (incremental), then a Disk to Disk running on Fri (Full), and then Disk to Tape running on the weekend (full duplicate).
One job out of all failed to run this weekend for some reason. After digging around, i noticed that the Job Recurring category for this job was set to No.
All the other jobs created via policy the same policy were still set to Yes.
I can recreate this job easily via policy, but i wanted to know what the reason for this change if possible.
Last week, 4 out of 5 jobs selection lists were cleared for some reason.
The policy i have for these is the same as mentioned above.
I noticed this issue becuase most of the jobs failed over that weekend. (the full duplicates, disk to tape).
When looking at those disk to tape jobs in the job setup tab, the selection lists were blank.
Could these issues be becuase of an issue with backup exec? anyone recemmond reinstalling or anything?