Video Screencast Help

Library Name = DEFAULT

Created: 25 Jul 2013 • Updated: 05 Aug 2013 | 2 comments
mudabo's picture
This issue has been solved. See solution.

We had a tape library (3494) that was taken down while Netbackup was processing, and new microcode was put on the library and the drives.   When it came back up, of course Netbackup could not connect to it.  We deleted the library, and went through the wizard to rediscover and configure it.  It kept comimg back as a libray name of DEFAULT, and not 3494 which is the library type.   We had to eventually,  remove the library again, and redefine it manually in tpconfig, Then run tpautoconf -a to get the library configured correctly.   Does anyone know why the name DEFAULT kept comimng up as the library name ?

Operating Systems:

Comments 2 CommentsJump to latest comment

mph999's picture

I suspect from the library itself.

I amnot too sure where you were seeing the wrong name, was this in the wizard ?

 

Try this, from the robot control host, run tpconfig -d

Make a note of the path to the library.  Then, run /usr/openv/volmgr/bin/scsi_command -r <path to library>

Example

(From tpconfig -d)   TLD(0)     robotic path = /dev/sg2
 
root@nbmedia00 robots $ /usr/openv/volmgr/bin/scsi_command -d /dev/sg2
Inquiry data: removable dev type 8h STK     L700            550V
 
For your library, do you get a name back ?
 
At the end of the day, this was working, you change the firmwar on the library and then it doesn't work - the only thing changed was the firmware.
 
Martin

 

Regards,  Martin
 
Setting Logs in NetBackup:
http://www.symantec.com/docs/TECH75805
 
SOLUTION
mudabo's picture

Thanks for your response.   The library is a TLH library  Just trying to understand what happened.   We got the library back, howbeit we had to add it via tpconfig and tpautoconf.   Thanks for your help again