Deployment Solution

After apply a image with Deployment, the PC don`t start normally.

You really need to elaborate a little more. What exactly is happening? Did you have DS do the post config? Is there an error in the console?

If you are just getting a black screen, that typically has to do with an incompatible HAL. Otherwise, please post what actually happens on the PC.

I install a pc with all programs that have been required, I generated the image properly, then I applied the image in a new computer, after that the new computer has an infinite loop in the logon/logoff.

So, you are saying that you get to the logon screen, try to logon and it logs you off? Or are you saying that it gets partly into Windows and reboots itself?

Yes, the computer start normally, when I login, inmediatly logoff in a loop. The computer is a HP DC5800, and I used WinPE for the boot disk.

The S.O is Windows XP Service Pack 3, and I installed McAfee, SAP, Office and hoffix and updates

Is there another account that you can logon to that machine with? Can you connect to the machine remotely to look at the event viewer? The only time I've seen that is if the machine is in the middle of doing Windows Updates, but the problem usually has gone away within a couple of reboots.

But the first pc is ok, no problem, where is the problem with the image application?

It could be still rebooting to finish the post configuration. Is this only happening on one computer or is everyone you image now doing it?

Yes, i used local and domain counts (administrators), and I restart the computer in safe mode, but the computer have the same problem

Do you use autoadminlogon? What happens if you disable that?

I don't use you used autoadminlogon, I choice the user (it have been the local or the domain administrator). Too, i restart the computer in safe mode (with the local administrator), and I have the same problem. May the image has been any problem? What can I do?

I have to apply the image in 3 computers, with the same problem....

I think at this point you may want to rebuild the image.

Ok, I rebuild the image and tell us. Thanks.