Mailboxes not being enabled very fast

rasobey's picture
rasobey
November 23rd, 2009

 Dear all,

On Friday we added about 100 users to a provisioning group where that group is automatically enabling users. We had around 100-110 users enabled already before that. On Friday night, only 127 mailboxes ("Active Archives" in the usage report) had been enabled. Same for Sunday morning. This morning there are 147 active archives. There are over 200 users in the provisioning group.

Why aren't these mailboxes being enabled? Our archive schedule is 6pm-midnight, and I am seeing event logs (2203, mailbox has been enabled) up to 1813 or so.

What can I check to resolve this? We want to be able to enable 200 users a night, but at the moment it seems we aren't even getting a tenth of that!

Thanks

Ricard

Filed under: ,
0 votes
Rob Wilcox's picture
Rob Wilcox
16 weeks 5 days ago

Do you have a trace of your

Do you have a trace of your provisioning task?

Thanks
Rob Wilcox
EV Engineering Support

0 votes
rasobey's picture
rasobey
16 weeks 5 days ago

 Hi Rob, I can send a report

 Hi Rob,

I can send a report of the provisioning run in full mode if that's what you mean? Or did you mean dtrace, in which case I'd need some guidance on what to do.

Also, out of interest, I ran the archiving tasks this morning and another 14 mailboxes were enabled across 3 Exchange servers. I didn't run provisioning beforehand. I'm seeing lots of these errors too:

Could not get a MAPI session from the session pool. 
Error: An event was unable to invoke any of the subscribers  [0x80040201] 

Thanks

Richard

0 votes