MR4MP2 NTP Won't Install
Updated: 21 May 2010 | 4 comments
This issue has been solved. See solution.
I just completed a manual, unmanaged installation of MR4MP2 (Build 4202) on Windows 2000 Server. I chose a custom configuration, and made sure NTP was selected, but alas, after a successful installation of SEP, NTP doesn't show up in the console as an installed feature. Is there anything in the install log I can check for to figure out the cause of this failure? I've uninstalled and reinstalled SEP twice and had the same result each time.
discussion Filed Under:
Comments
Please try performing a
Please try performing a modify installation from Add/Remove Program,
Make the feature, NTP installed in the wizard.
On a serious note, Do not install NTP on Server OS, unless the server is playing a role of a workstation.
Prashant Bharadwaj, CEH, MCTS Windows Server 2008 Active Directory, Configuration, SCS Symantec Endpoint Protection 11.0
Use the .msi pakage to
Use the .msi pakage to install. It is located in SEP folder of CD1
Regards'
Ajit Jha
Technical Consultant
STS
See Symantec Endpoint
See Symantec Endpoint Protection 11.0 Network Threat Protection (Firewall) Overview and Best Practices White Paper
http://service1.symantec.com/support/ent-security....
About NTP...
NTP does not show up on the Endpoint Protection client as soon as the installation is complete. It requires a reboot after the installation.
Check this document for more info....
Network Threat Protection does not appear in the user interface after installing Symantec Endpoint Protection
http://service1.symantec.com/support/ent-security.nsf/docid/2008031118335548
Regards,
Ash
Would you like to reply?
Login or Register to post your comment.