Video Screencast Help

Multicast session takes to long to time out failed systems

Created: 13 Dec 2013 | 3 comments

I am looking for a way to change the configuration in ghost to change the timeout time on a multicast session where the entire session is limited by the failure of one bad hard drive. (When we are unaware of a failed hard drive) Is there a way to change the amount of time on one failed drive on a session of 30 computers to time out faster so the session can continue at a normal rate of speed? I have seen sessions when the timeout takes well over 10, to 20 minutes to finally proceed after the failed drive finally times out and fails. If I can time out such failures in say, 30 seconds, that would definitely boost productivity.

Any help or instructions where I can modify this configuration in ghost would be highly appreciated not only by me, but by our school district of over 10,000 computers. Thanks

Gene M. Tech Specialist I

(El Paso Independent School District Texas)

Operating Systems:

Comments 3 CommentsJump to latest comment

EdT's picture

Can you confirm the version of Ghost you are using?

If your issue has been solved, please use the "Mark as Solution" link on the most relevant thread.

EdT's picture

Please run LiveUpdate to bring the version to the latest available which is 11.5.1.2266

If your issue has been solved, please use the "Mark as Solution" link on the most relevant thread.