problem with cleaning tape
I have problem with cleanning tape in BE 2012. I have a Library ML6000 with LTO3 (2-drives). And configured 1 slot with Library for clean slot. I change celan tape in new, and now i don't see this tape with my BE 2012, but this tape is located with Library. When I backup my project i have a problem:
The job failed with the following error: A backup storage read/write error has occurred.
If the storage is tape based, this is usually caused by dirty read/write heads in the tape drive. Clean the tape drive, and then try the job again. If the problem persists, try a different tape. You may also need to check for problems with cables, termination, or other hardware issues.
If the storage is disk based, check that the storage subsystem is functioning properly. Review any system logs or vendor specific logs associated with the storage to help determine the source of the problem. You may also want to check any vendor specific documentation for troubleshooting recommendations.
And error ceaning tape:
Tape alert - attempting to clean drive.
Tape alert - the drive was not cleaned. No cleaning media found.