Video Screencast Help
Give us your opinion and win with Symantec! Please help us by taking this survey to tell us about your experience with Symantec Connect, so that we can continue to grow and improve.  Take the survey.

problems with llt manual installation

Created: 15 May 2013 • Updated: 28 May 2013 | 3 comments
This issue has been solved. See solution.
root@solaris11-chi-1:/etc/VRTSvcs/conf/config# cat /etc/llttab
set-node solaris11-chi-1
set-cluster 7777
link net2 /dev/net/net2:0 - ether - -
link net3 /dev/net/net3:1 - ether - -
root@solaris11-chi-1:/etc/VRTSvcs/conf/config#
 
 
root@solaris11-chi-1:/etc/VRTSvcs/conf/config# cat /etc/llthosts
0 solaris11-chi-2
1 solaris11-chi-1
root@solaris11-chi-1:/etc/VRTSvcs/conf/config#
 
 
root@solaris11-chi-1:/etc/VRTSvcs/conf/config#  /lib/svc/method/llt start
Starting LLT...
LLT lltconfig ERROR V-14-2-15040 node ID is already set, use -o to override
Could not start LLT successfully.
root@solaris11-chi-1:/etc/VRTSvcs/conf/config#
 
Operating Systems:

Comments 3 CommentsJump to latest comment

mikebounds's picture

Try running "lltconfig -U" first.

Then you can run "lltconfig -c" to start LLT (or use  /lib/svc/method/llt start which loads LLT kernel module, which are already loaded and starts LLT)

Mike

UK Symantec Consultant in VCS, GCO, SF, VVR, VxAT on Solaris, AIX, HP-ux, Linux & Windows

If this post has answered your question then please click on "Mark as solution" link below

SOLUTION
arangari's picture

i think the message indicates that on the inter-connect network, there already exist node-id '1' with cluster id 7777.

look into the /etc/llttab and /etc/llthosts on solaris11-chi-2. Also there could be other nodes connected to same interconnects (net2 and net3) having the same cluster-id.

i think there was some way to find this out using llt-command. will check and getback

Thanks and Warm Regards,

Amit Rangari

If this post helped you resolving the issue, please mark it as solution. _____________________________________________________________________________

starflyfly's picture

Hi,

1.  modify  /etc/llttab:

==============

set-node solaris11-chi-1
set-cluster 7777
link net2 /dev/net/net2:0 - ether - -
link net3 /dev/net/net3:1 - ether - -
============
 
set-cluster  id to a different  number like:1234
=============
set-node solaris11-chi-1
set-cluster 1234
link net2 /dev/net/net2:0 - ether - -
link net3 /dev/net/net3:1 - ether - -
============
 
make sure also  change another node  to same cluster id.
 
2. start llt again:
 
/lib/svc/method/llt start
 

If the answer has helped you, please mark as Solution.