Redirected Restore
Created: 24 May 2012 | 6 comments
Hi All
Today I was reading the NetBackup 7.1 Admin Guide on the redirected restore part, when talking about few ways to allow clients to perform redirected restores (altnames\No.Restriction; altnames\peername, etc), I noticed that there were few notes
"Note: The information in this topic applies to restores made by using the command line, not the Backup, Archive, and Restore client interface."
Just wonder why it's not applied to restore using BAR interface? In my experience these configuration also apply to BAR restore.
Thanks!
Leo
Discussion Filed Under:
Comments 6 Comments • Jump to latest comment
I think you are right ... I think, that is wrong.
I will test it, and then send an email to the author of the manual, if we are correct.
Martin
OK, tested - backuped up server a, tried to restore file to server b using BAR gui - it failed. Created touch file, it worked ...
Manual appears to be wrong.
I have sent a mail to the author of the manual explaing the concern, and the steps I took to test it.
Hope this is OK, best I can do.
Martin
Thanks Martin, I have done the redirected restore before, and know the configuraiton works for the BAR restore, just wonder there must be a reason to put the "Note" there.
Thanks again for your help.
Leo
will let you know if i find a reason M
will let you know if i find a reason M
An eTrack has been created to investigate if this is changed behavior.
M
Would you like to reply?
Login or Register to post your comment.