Hello,
Recently we fixed some protocol conflicts and I know am able to install PXE to remote PCs over the WAN again. Every thing is working however it takes forver for PXE COnfig Util to complete updating after I install PXE to a location. Is this because I have 4 seperate automations set up? In other words, these are my Shared Configuration, two of which use UNDI driver. I notice a lot of the traffic through the package shaper appears to be NIC driver info. If so, is there away to only allow my DOS redirect automation type to be shared remotely? Hope this makes sense. Just trying to figure out why over 200mb of data is going from my DS here to whichever remote site I install PXE to. Thanks.
CH