Video Screencast Help
Give us your opinion and win with Symantec! Please help us by taking this survey to tell us about your experience with Symantec Connect, so that we can continue to grow and improve.  Take the survey.

Replication Status is not showing from Primary Site

Created: 03 Apr 2014 | 3 comments
Zahid.Haseeb's picture

Environment

SF = 6.0.1

OS = 2008R2from start , it gives an e

Query

Replication status does not showing when I see from VEA (Primary Site). However replication status is showing fine when I see from VEA (DR Site). See the below snaps from Primary and DR site.

1_.png

DR Site Status above

============================================================================

11_.png

Primary Site status above

Operating Systems:

Comments 3 CommentsJump to latest comment

Wally_Heim's picture

Hi Zahid,

I'm thinking that the vxsvc service (Veritas Enterprise Administrator service) needs to be restarted to refresh the object bus with the correct VVR details.

You can run "vxprint -VPl" from a command prompt on the primary to see if it shows the RDS on that node.  If it does then I would restart the vxsvc service and see what it looks like in VEA after that.

As always, you can open a case with Symantec Technical Support and will assist with troubleshooting this issue directly.

Thank you,

Wally

Zahid.Haseeb's picture

Thanks Wally :) Sure I can open a case with Symantec

=======================================

vxsvc service (Veritas Enterprise Administrator service) needs to be restarted

I even restart the node but same status

=======================================

vxprint -VPi

Diskgroup = BasicGroup

Diskgroup = XXxXX

Rvg        : XXxXX_replication
state      : state=ACTIVE kernel=ENABLED
assoc      : datavols=D:
             srl=\Device\HarddiskDmVolumes\XXxXX\XXxXXSRL
             rlinks=Tracker_PRI
att        : rlinks=Tracker_PRI
checkpoint :
flags      : primary enabled attached read write

Rlink      : Tracker_PRI
info       : timeout=60 packet_size=1400
             latency_high_mark=10000 latency_low_mark=9950
             bandwidth_limit=none
state      : state=ACTIVE
             synchronous=override latencyprot=off srlprot=autodcm
assoc      : rvg=XXxXX_replication
             remote_host=XXxXX-DR {192.168.1.232}
             remote_dg=XXxXX
             remote_rlink=Tracker_SEC
             local_host=XXxXX {192.168.1.44}
protocol   : UDP/IP
flags      : write attached consistent connected

Any comment will be appreciated. Mark as Solution if your query is resolved
__________________
Thanks in Advance
Zahid Haseeb

zahidhaseeb.wordpress.com

Wally_Heim's picture

Hi Zahid,

The CLI output looks good.

Is the primary site a multinode cluster?  If so do you get the same results when the group is on another node in the cluster?  I'm wondering if there is an issue with the VVR license might not be installed on the problem node??

If it is a single host or it is not a licensing issue, then I would recommend opening a support ticket so that we can troubleshoot/investigate this issue further.

I would recommend having vxexplorer logs from all nodes in the primary and secondary sites ready for Technical Support.  I'm sure they will also need screen shots but they might be able to get them via webex if your are OK with that.

Thank you,

Wally