Endpoint Protection

Hi all,

I need some advice. How can clients reach/communicate with SEPM when this latter is using a NATted IP address : say the real address of SEPM is 192.168.x.x but it is reachable only through 172.16.x.x.

I think of something like : editing directly sylink.xml and replace the IP address before deploying clients but is it safe to do so ? Or is there an another way to solve this problem ?


Thanks in advance

check this one out..hope this could help

http://service1.symantec.com/support/ent-security.nsf/docid/2009032408115648

I not sure.. but try this...

First install the server with 17.X.X.X series... then install few clients and connect to SEP.

After that change the server IP t o192.X.X.X series.. If sepm service doesn't start reconfigure the management server....

Now try whether Clients are able to reach....  ?

Good one pete.. 

As SHP point it, good one Pete. I'll try it and this week end. 

 Working like a charm, thanks for both of you guys.

Never thought it could be done, good work sHP and Pete..

Thanks all of u... Mine was just a clue.. Pete gave the KB.. Good work pete...