Hi all,

 

I've recently installed SEP MR1 and have been in the process of rolling out and configuring clients.  Everything has been fine until a couple of days ago when the SEPM server started issuing the message "an unexpected error has occurred [site:] [server:]" about every minute.  Since then, no update definitions have been pushed to clients nor have any policy changes been pushed.  LUALL continues to run and SEPM lists the correct definition versions, they just are not going out to clients.

 

I found a kbase article that seemed to describe this problem however the described solution of setting one of the SEP services to manual didn't apply to this system (it was already manual).

 

I've posted a support request on this problem, but I was curious to see if someone else had seen it.

 

Thanks!