Endpoint Protection

I am upgrading SEPM to the latest ver. I have 2 management consoles and a DR site. Do I upgrade all 3 consoles at the same time and then reboot? Or do I upgrade the 2 consoles, reboot and then do the DR site? I am not sure if disabling replication will be enabled after the upgrade and reboot? Thanks

 

If any are replicating you need to break it then do the upgrade then reenable it, is DR replicating or are all?

You need to break replication

Turning off replication before upgrade

Article:HOWTO81188

|

Created: 2012-10-24

|

Updated: 2013-10-07

|

Article URL http://www.symantec.com/docs/HOWTO81188

Turning on replication after upgrade

Article:HOWTO81207

|

Created: 2012-10-24

|

Updated: 2013-10-07

|

Article URL http://www.symantec.com/docs/HOWTO81207

Yes DR is replicating. Should I upgrade all 3 SEPM at the same time or can I stop replication, upgrade the 2 main consoles, reboot and then upgrade DR site, reboot and start replication?

 

You need to break all replication, upgrade them, then re enable it. Nothing can be replicating while the upgrade is going on

You need to break replication before upgrade after upgrade you can enable it.

You are require to stop the replication first then upgrade the SEPM. After upgrade enable it again.

I understand that replication needs to stop. I was wondering if I can stop replication , upgrade both of my cansoles and reboot. When it comes up successfully upgrade DR, reboot and turn on replication?

I have 2 SEPM consoles and 1 DR

 

No, they all need to be done at the same time. You cannot replicate two different versions or you risk corruption.