sorry if my english was bad

so i've installed SEPM on my server, 

my network in here was using VLAN

i wanna installed and managed SEPM from server to client,

but, i've had problems and doesnt understand what to do,

when i've installed then i want to deploy to the client install, it only reads my Groups(server group) and didn't recognize by other groups

i want it reads all groups in VLAN.but if i deploy by IP it works, but i need it can reads VLAN Group (Group server, 1st floor, 2nd floor, dll)

so it was centralized and i can monitored it from server. i'm using IIS in my windows server 2003

i hope you understand what i meant, 

or the easiest way to explain : anyone can help me to apply SEPM on VLAN Groups

Best Regards

Wahyu

Hi Ashish..

it's enable to ping or to deploy by IP address, but i can't read another groups of networ/VLAN

FYI, it only can read my server group of VLAN

but can't read another groups.but if i'm deploy by IP it success but alway request administrator password,

it became home works for me to add by IP and remarks who's IP is active and inactive

so my question is how to read another VLAN groups,

example from server groups i can read groups of 1st floor, 2nd floor and others so i don't have to deploy by IP

there is a way to do that?

Hi Ashish Sharma

The Ouput is looking like this :

what shoul i do?

because i check it from client to server

is that correct?

or the reverse?

if the reverse is looking like this

Connection to 192.168.x.x..Could not open connection to the host, on port 80:Connect failed

Dear Ashish Sharma

follow your advice, right now port 80 in symantec server is open

status is Listening

but i've tried to telnet again port 80 192.168.1.222 80

the reply is always error like my posting before

any another suggest?

Thanks And Regards

Wahyu

Thanks Asish for your explanation

what should i do if the port is open??

there special setting to read the other groups of VLAN?

or just the same way to install it?