SMG Initial Setup: IPs for both interfaces?
I am setting up a SMG appliance in the near future and am a bit confused on how best to configure the appliance. I am going to define the appliance as a combined Control Center and Scanner and the Scanner will do both inbound and outbound scanning.
I will use both of the ethernet interfaces, giving them example IP addresses of 192.168.70.70 and 184.108.40.206. According to the documentation, these are both defined at time of initial appliance setup.
When I create the Scanner, the documentation indicates that I will be prompted to Create Virtual IP Address. I can select the ethernet interface, but then I should type the IP address for the virtual server. This is where I get a bit confused. It seems that I need to type another IP for an interface that has an IP already defined in initial setup?
Any help and guidance would be very much appreciated.
thanks in advance!