SSR 2013 BSOD (blue screen) When Backing Up Server
Created: 22 Jan 2013 | 8 comments
We are testing Symantec System Recovery 2013 on a Windows 2008 R2 SP1, fully patched server (Hyper-V Guest, single disk volume). After installation, when we attempt to run a full server backup, the job starts, gets to 5% (progress and performance shows "snapping volumes") and then crashes the server. Blue screen states: "a wait operation, attach process or yield was attempted from a DPC routine. STOP: 0x000000B8," and down she goes!
Comments 8 Comments • Jump to latest comment
Hi,
Is it observed everytime backup is started on this server or just one occurance?
-Thanks,
Pravin
This happens every time a backup is initiated.
I found a KB article with the same symptoms due to incompatibility between Acronis symsnap and Storage Craft Shadow Protect snapman. We have previously done a trial of Shadow Protect on this server. Might be a clue.
It is normally not recommended to have multiple backup solutions active on same machine. It could result in conflicting drivers trying to consume same windows resources resulting in BSOD.
Please uninstall Shadow Protect as well as make sure that its drivers are also removed and retry backup using SSR.
Please let me know your observation.
-Thanks,
Pravin
Memory.dmp from c:\windows will be required to investigate this issue. Please open a support case for further investigation and resolution of the issue.
-Thanks,
Pravin
I removed Shadow Protect before ever installing SSR. Thanks.
Hi,
We'll need memory dump for analysing the cause of this BSOD. Even if you uninstalled Shadow Protect, you can check for stale entries of its driver in c:\windows\system32\drivers folder.
-Thanks,
Pravin
If you have a support contract with Microsoft, I would advise you to collect a memory dump (as advised above) and get Microsoft to analyze it.
Even though the issue is seen when running a SSR backup, does not mean it's an SSR issue. Memory dump analysis will tell us more.
Please mark thread as solved if you consider this to have answered your question(s)
Would you like to reply?
Login or Register to post your comment.