Symantec Brightmail Gateway 8.0.2-12 configuration
Updated: 21 May 2010 | 4 comments
This issue has been solved. See solution.
Hi.
I am trying to set up brightmail gateway for the first time.
Installation seems to have completed without any issues. It has been installed on a virtual server.
I have set two separate ip adresses for the two nic's.
Also enabled http.
But I am unable to access it from another computer in the same subnet.
I installed both the management and software.
Any idea what I need to do to be able to access the management ?
discussion Filed Under:
Comments
I tried to access the server
I tried to access the server where the control center is installed just by typing http://and the ip adress. Page cannot be found.
I also tried to type https://ip adress and thwn I get a white page after clicking ok on a security message.,
Hi, to access you shoud use
Hi,
to access you shoud use https://<hostname> where hostname can also be the IP address. Make sure you're using one of the supported browsers. This is IE 6.x, 7.x or Firefox 2.x, 3.x. You may encounter problems with IE 8
You need to accept (and / or add an exception for the self-signed certificate).
Also have a look at the "getting started guide" for more information about setting up SBG.
Regards,
Federico
Hi. Thanx for the reply. The
Hi.
Thanx for the reply. The solution was to open it from Firefox 3x instead of IE8.
Problem in outbound mails
Hello,
Our senario is as follows;
Our MX record IP (Public IP) is assigned in Cisco ASA 5510 firewall and inbound traffic to this IP forwarded to a local IP which is the NIC 0 of BrightMail Gateway.
After scanning the mails forwarded to Exchange Server (Local IP)
Above is working fine but out going mails are not working;
In Exchange server mails are forward back to BMG (to above local IP - NIC 0) for outbound. From here I don't know how to configure smart host.
Could you please explain me how to configure for the BMG in our environment
Thanks
Would you like to reply?
Login or Register to post your comment.