Video Screencast Help

Where can I see the latest lan enforcer installation and administrators guide?

Created: 27 May 2013 • Updated: 17 Jun 2013 | 10 comments
D@ry1's picture
This issue has been solved. See solution.

Hey Guys,

Where can I see the latest lan enforcer installation and administrators guide? I've been looking around symantec but all I see is 11.x  manuals. Or there's no 12.1.x installation and administrator manual yet?

Thanks,

Comments 10 CommentsJump to latest comment

ᗺrian's picture

Wasn't there anything in the documentation folder on the install DVD?

Symantec™ Endpoint Protection 12.1.2 Installation and Administration Guide

http://www.symantec.com/docs/DOC6153

Please click the "Mark as solution" link at bottom left on the post that best answers your question. This will benefit admins looking for a solution to the same problem.

D@ry1's picture

Hey,

We have this but I didnt see any lan enforcer installation specific on this document. taht's why I'm asking if there's a seperate manual for it.

Thanks,

pete_4u2002's picture

It'a appliance correct? so you need to install iso image and then configure as per the link below

check this link

 Symantec Endpoint Protection and Symantec Network Access Control Implementation Guide 12.1

http://www.symantec.com/docs/DOC4321

Mithun Sanghavi's picture

Hello,

I agree with pete's suggestion above.

There is no seperate SNAC implementation guide in SEP 12.1

You can check the Section 4: Managing network compliance with Symantec Network Access Control on page 657 from the Symantec™ Endpoint Protection and Symantec Network Access Control Implementation Guide provided in the Article.

Symantec Endpoint Protection and Symantec Network Access Control Implementation Guide 12.1

http://www.symantec.com/docs/DOC4321

Hope that helps!!

Mithun Sanghavi
Associate Security Architect

MIM | MCSA | MCTS | STS | SSE | SSE+ | ITIL v3

Don't forget to mark your thread as 'SOLVED' with the answer that best helped you.

sandra.g's picture

Just for general info, bear in mind that this version of the Guide is from the initial release of SEP 12.1. The newer (12.1.2) document would supercede it.

sandra

Symantec, Senior Information Developer
Enterprise Security, Mobility, and Management - Endpoint Protection

Don't forget to mark your thread as 'solved' with the answer that best helps you!

sandra.g's picture

Looking into this. The document attached to the page that Brian provided should have SNAC information, but it is missing.

On disc one of your downloaded disc image, in Documentation, Installation_and_Administration_Guide_SEP12.1.2.pdf has SNAC info; see Section 7: "Managing Symantec Network Access Control."

sandra

Symantec, Senior Information Developer
Enterprise Security, Mobility, and Management - Endpoint Protection

Don't forget to mark your thread as 'solved' with the answer that best helps you!

sandra.g's picture

Update: The correct version of the 12.1.2 admin guide (including information for SNAC) has been restored to the following page:

Symantec™ Endpoint Protection and Symantec Network Access Control 12.1.2 Installation and Administration Guide
http://www.symantec.com/business/support/index?pag...

sandra

Symantec, Senior Information Developer
Enterprise Security, Mobility, and Management - Endpoint Protection

Don't forget to mark your thread as 'solved' with the answer that best helps you!

SOLUTION
sandra.g's picture

Thank you for the post--otherwise we might not have been aware of the error! smiley

sandra

Symantec, Senior Information Developer
Enterprise Security, Mobility, and Management - Endpoint Protection

Don't forget to mark your thread as 'solved' with the answer that best helps you!