Hi eddiem1976
Here is the step by step instruction and it is for winPE.
Please make sure the windows Vista 32 bit drivers are added to winPE .
PXE Installation procedure :
1. Open the Ghost Solution Suite setup folder .
2. Run Master.exe located in Extras > 3Com Boot Services > Master.exe
3. Click on Install 3Com Boot Services .
4. Click Next ... and select Server under Setup Type .
5. Click Finish to complete the installation.
==================================================================================
PXE configuration :
- Install 3COM Boot Services
- Open Ghost Boot Wizard and select Image Type
TCP/IP Network Boot Image (To run Ghost Cast Server and PXE)
TCP/IP Network Ghost Client Boot Image (To run Ghost Console and PXE)
- Please click Next until the TCP/IP Network Boot Image window.
- Please select the TFTPBOOT folder under TFTP Root Directory and assign a Name for the Boot
Package
- Click Next and create boot package
- Copy the bootmgr.exe from the boot folder under TFTPBOOT folder to TFTPBOOT folder
- Open the BOOTPTAB Editor
- Click Edit > Add Host
- Check Use node for name
- Under node field type question marks (?) as far as it goes (12 question marks )
- Under Image field , type /boot/pxeboot.n12
- Click on OK
- Click File > Save As
- Save with the filename BOOTPTAB in TFTPBOOT folder
- Start PXE server and then TFTP server (Start > all programs > 3COM Boot Services)
Then Network Boot the client computer and it will boot to Ghost.
Note: If the DHCP is on the same server please say NO to Proxy DHCP prompt when the PXE
server is opened.
If the DHCP is not on the same server please say YES to Proxy DHCP prompt when the PXE
server is opened.
Please reply back for any clarifications.